#PML 9589 GM Turbo 350 LoPro

Volume: stock capacity

Dimensions: Click here for dimensions. Although this pan is stock capacity, it is still larger than the stock pan. Always check your vehicle for clearance before ordering.

Number of Bolts: 13

This PML pan fits the GM TH350 (Turbo-Hydramatic 350) transmission. The transmission was first available in 1969 after joint development by Buick and Chevrolet. It first appeared in cars and moved to trucks and SUV models. The transmission continued in production in the 1980s.

The Turbo 350 is found in GM (Chevy, Cadillac, Olds, Buick) vehicles as well as retrofitted Jeeps and other cars and trucks. Originally, the GM TH350 transmission was originally on 1967 to 1972 El Caminos, Blazers, and C/K 20 trucks and Suburbans.

The TH350 transmission is called Turbo 350 in the racing field and is formally called THM350 for Turbo-Hydra-matic 350.

Always check your vehicle to verify transmission and clearance. This PML pan will fit the Turbo 350 transmission, but it is larger than stock. Make sure to check for clearance with the drive shaft and bosses on the passenger's side.

PML also offers a deep version of this pan with extra fluid capacity. The deep pan, PML part number 9684, does not have the external bosses that may interfere with the drive shaft on some vehicles.

The pan has a boss near the drain that can be machined for a temperature sensor unit (machining is optional).

PML Transmission Pan Compared to Stock

  
Click on image to view larger.

These images show this PML transmission pan compared to the stock pan.

Installation on a 1960 Willys

Dave installed this PML transmission pan on his Willys with a Chevy 350 engine and TH350 transmission.

      
Click on image to view larger in a new tab or window.

PML Transmission Pan Features:

• Sand-cast aluminum with raised fins
• 3/16-inch thick wall construction to add strength to the transmission case
• 3/8-inch thick gasket flange will not bend when bolts are tightened
• Machined gasket surface for a secure seal
• Boss cast into pan can be machined for a temperature sensor
• Drain hole and magnetic drain plug for easier, less messy maintenance

All PML transmission pans ship with new mounting bolts and a magnetic drain plug.

If you would like PML to machine your pan for a temperature sending unit, there is an additional charge of $45 .