#PML 9917 GM 200-4R DEEP

Volume: 2.5 qts. over stock

Dimensions: Click here for dimensions.

Number of Bolts: 16

This PML deep pan fits many models of rear wheel drive cars with 4-speed automatic transmissions. GM used this transmission from 1982-1990. Examples of vehicles using the 200-4R transmissions are:

• Buick Regal T Type
• Grand National
• Chevrolet Monte Carlo SS

PML designed this pan to meet the demands of these high performance cars.

For a gasket, PML generally recommends cork or cork and rubber type gasket.

Inside of Pan

In the interior, the pan features cast-in baffles.

Click on image to see a larger picture of the inside of the pan. A separate window will open and load the image.

Filter Information

This PML pan works with stock filters. Example part numbers are: AC Delco TF234, Fram FT1057B, Fram FT1057C, Hastings TF60, Purolator P1194, Wix 58896

PML 200 4R transmission pans have filter supports so a filter extension is not needed.

The supports hold the filter at the same level as the stock pan. The distance from the bottom of the stock pan to the top of the flange is 2.4 to 2.6 inches. The distance from PML filter supports to the top of the flange is the same. The stock filter is about 4.8 inches tall.

This shows the inside of the stock and PML 200 4R pans:

Some customers have reported to us that a 700R4 filter may also work with our 200 4R transmission pans. PML does not have any experience with this or recommend this.

Filter information is provided for reference only. Installer should verify transmission, filter and fitment based on the individual vehicle.

Drain Location

The PML deep 200 4R transmission pan has a drain on the driver side of the pan. (Click on image to view larger.)

A magnetic drain plug is included with each pan.

Optional Temperature Sending Unit Machining

A boss (thick area) on the passenger side of the pan is available for drilling and tapping if requested by the customer.

For example, the passenger side boss can be machined for a temperature sending unit. For PML to machine the hole, there is a $45.00 charge. A plug is included.

Click on image to view larger.

PML Transmission Pan Compared to Stock

  
Click on image to view larger.

These images show this PML transmission pan compared to the stock pan.

PML Transmission Pan Features

• Increased oil capacity for cooler temperatures
• Sand-cast aluminum with raised fins
• 3/16-inch thick wall construction to add strength to the transmission case
• 3/8-inch thick gasket flange will not bend when bolts are tightened
• Machined gasket surface for a secure seal
• Boss cast into pan can be machined for a temperature sensor
• Drain hole and magnetic drain plug for easier, less messy maintenance

All PML transmission pans ship with new mounting bolts and a magnetic drain plug.

If you would like PML to machine your pan for a temperature sending unit, there is an additional charge of $45 .